Kingston DDR3 16GB 1600MHZ VALUERAM 2X8G CL11

16GB Kit (2x8GB) – DDR3 1600MHz
Part Number: KVR16N11K2/16
HTS: 8473.30.1140, ECCN: EAR99
Specs: DDR3, 1600MHz, Non-ECC, CL11, 1.5V, Unbuffered, DIMM, 240-pin,

DESCRIPTION

ValueRAM’s KVR16N11K2/16 is a kit of two 1G x 64-bit (8GB)
DDR3-1600 CL11 SDRAM (Synchronous DRAM) 2Rx8, memory
modules, based on sixteen 512M x 8-bit FBGA components per
module. Total kit capacity is 16GB. The SPDs are programmed
to JEDEC standard latency DDR3-1600 timing of 11-11-11 at
1.5V. Each 240-pin DIMM uses gold contact fingers. The
electrical and mechanical specifications are as follows:

FEATURES

• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL – 2, or CL – 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB : Height 1.180” (30.00mm), double sided component

SPECIFICATIONS

CL(IDD) 11 cycles
Row Cycle Time (tRCmin) 48.125ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 35ns (min.)
Maximum Operating Power 2.580 W* (per module)
UL Rating 94 V – 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
*Power will vary depending on the SDRAM used.